Vaginal Electromyography

This sensor is specially designed for high-performance pelvic floor EMG data acquisition.

The biosignalsplux Vaginal EMG sensor is a modification of the biosignalsplux EMG sensor to provide compatibility with the intra-vaginal probe Periform® (Neen)* and is designed for pelvic floor EMG data acquisition.

The bipolar configuration is ideal for uncompromised low-noise data acquisition, and the raw data output provides medical-grade data enabling it to be used for advanced and highly accurate biomedical, electrophysiology, and rehabilitation research (e.g. development of new urinary incontinence treatment methods).

* probe not included

  • Pelvic floor EMG
  • Medical-grade intra-vaginal probe
  • Bipolar differential measurement
  • Medical-grade raw data output
  • Ready-to-use & miniaturized form-factor
Range ±1.5mV
Bandwidth 25-500Hz
Consumption ~1mA
Connector Type UC-E6 (Male)
Consumption ~1mA
Input Impedance >100GOhm
CMRR 100dB
Cable Length 100cm±0.5cm (customizable)

This sensor is not a standalone use sensor and requires the use of a biosignalsplux hub. It can be used with the following biosignalsplux kits and systems for data acquisition:

Electromyography (EMG) Analysis

This add-on is designed to extract useful statistical temporal and spectral information from electromyography data acquired with the Electromyography (EMG) sensor. Its automatic onset detection algorithm is designed to detect muscle activations in the EMG signal, allowing the user to select and derive activation-specific parameters for further analysis of the EMG signal. The onset detection algorithm can be fine-tuned for application-specific muscle activation detection by defining the frequency ranges of interest using the available low pass, high pass, and band pass filters.

Find Out More

You might also like these